DirectBikes -DB50QT-11 Especificações

Manual-DB50QT-16

9Guide to OperationIgnition Switch(1) position Turn the switch this positionto start the engine; the switch key can notbe pulled out in this posi

10NOTE:In hot weather, leaving the engine idling for a long time will cause it to overheat. You should shut it down to let it get cool.Headlight beam

11Start button (4) When this button is pushed, the starting motor works to start the engine. See the part “Starting the Engine” for

12Important ChecksThe scooter is nearly ready to go, but before you put any petrol or oil into the scooter, there are a few nal things that need chec

13BrakesChecking the front brakeCheck the brake for normal performance and adjust it’s free play. The free play refers to the distance for which the f

14Checking the tyre pressureThe tyre pressure is 1.75 bar for the front tyre and 2.0 bar for the rear. If you are carrying passengers or luggage pleas

15SuspensionThe suspension should be nice and free and should return to its normal position when bounced up and down. There should be no leaks.Fuel /

16ElectricsPlease go through the controls and make sure that the following systems are working correctly; Indicators: left and right, front and rear.

General ‘walk around’Before use please go around the scooter and check that all nuts and bolts are tight and secure and that there are no loose parts.

Riding the ScooterPlease always wear a HELMET and PROTECTIVE CLOTHING! Familiarise yourself with the controls BEFORE you go out on a public road. Take

1Dear Customer:Thank you for purchasing the Direct Bikes DB50QT-16 scooter.The Direct Bikes DB50QT-16 scooter is manufactured using some of

19CAUTION:Always start the engine with the rear brake pedal depressed.The engine should not be allowed to run too fast when it is being warmed up. Qui

20StorageWhen not using your scooter a waterproof cover should be used to protect the scooter from the elements. If storing the scooter f

CleaningYour new machine should be cleaned on a regular basis. This stops the ingress of corrosion, maintains its lustrous nish and gives you a chanc

22

23Repeat same service intervals when exceeding 31000kms / 64 months from the table above.

24TroubleshootingChecking the carburettorIn the unlikely event that your scooter fails to start please check the air pilot screw on the side of the ca

25Checking the spark plugA dirty spark plug with dirty electrodes or excessive gap between electrodes will not be able to generate ful

26Checking the fuseTurn off the master switch and check the fuse to see if it is blown. Replace the blown fuse with one of the specied capacity:• Al

CAUTION: • When removing the fuse, do not expand the fuse clamp too wide. • After the fuse is installed, check the fuse clamp to see if it runs loo

28Safety PrecautionsIt is only the driver that can ensure the safety of travel.A safety-minded scooter driver always spends much time learning how to

2Important Notice:• Driver and passenger This vehicle is designed to carry only one driver and one passenger. The driver is required to have the

295. As most serious scooter accidents cause injuries of the drivers head, always wear a helmet and protective clothing such as protect

306. Always remember to switch on the turn signal lights before making a turn or change lanes.7. Do not drive your vehicle on the shoulde

3Location of Component parts(1) Back-view mirror (2) Headlight (3) Front turn signal light(4) Mufer (5) Taillight (6) Seat

4Meter Panel and IndicatorsAll the controls for the indicators and warning lights are located on the meter panel. (1) Speedometer(2) Mileometer(3) Hig

5IdenticationThe VIN or chassis number is located on the frame of the scooter and is either under the seat or under the clip in cover in the front of

6Fitting the accessoriesScreenThe screen mounting kit utilises the mirror mounts to x it to the scooter. Start by sliding 2 of the plastic

7Top boxThe top box is supplied with a universal tting kit. Place the top box centrally on the rack. Hold the long slotted bars

8Fitting the battery Make sure the scooter ignition is in the off position. Put the battery in the compartment. Fit the 2 red leads (sometimes one or